top of page
< Back
Kvaser U100-C

Kvaser U100-C

01340-7

The latest laptops and PCs come with USB-C slots only, so the Kvaser U100-C (01340-7) has been added to Kvaser�s U100 range of robust, single-channel CAN/CAN FD to USB interfaces. This interface is based on the standard Kvaser U100 with DB-9 connector, but replaces the standard USB type �A� connector with the smaller USB-C format. As with other devices in the range, this is powered via the USB bus.�Robust, galvanically-reinforced (Tested according EN 60335) and signal and power isolated, the Kvaser U100 range offers enhanced electrical protection, a vibration, shock and drop-proof housing and high-quality cabling that establishes a new reference in CAN interface design. Other variants of the U100 range pair a standard USB type �A� connector with a 9-pin D-SUB, M12 or OBD-II CAN connector. A Precision version is also available - the Kvaser U100P - with a standard USB type �A� connector to a 9-pin D-SUB.
Major features: - Supports CAN FD, up to 8 Mbit/s (with correct physical layer implementation). - Supports both 11-bit (CAN 2.0A) and 29-bit (CAN 2.0B active) identifiers. - Supports silent mode for analysis tools � listen to the bus without interfering. - Reinforced Galvanic Isolation. (Tested according EN 60335-1:2012 paragraph 13, 5000VAC rms applied for 60 seconds) - 20 000 msg/s, timestamped with a resolution of 100 �s. - Industrial grade temperature range, ?40 oC to +85 oC. - USB-C connector. - Powered through the Type-C USB connector (a Type-A USB connector is also available). - DB-9 connector (other connectors available). - Supports bit rates from 10 Kbit/sec up to 1 Mbit/sec. - Lightweight, glass fibre reinforced polyamide housing, overmolded with TPE. - IP67 rated. - Intuitive LED UI. - Support for SocketCAN. - Compatible with J1939, CANopen, NMEA 2000� and DeviceNet. - Fully compatible with applications written for other Kvaser CAN hardware with Kvaser CANlib.
bottom of page